CM880 AUTOPILOT SYSTEM SPECIFICATIONS
INPUT VOLTAGE: 10-35 VDC
ENVIRONMENTAL: 0-50degC
STEERING SYSTEM TYPES: Hydraulic, solenoid activated
POWER CONSUMPTION: Standby: 0.3A at 12 - 24V
HEADING SENSORS: Coursemaster CM427 Fluxgate, or CM428 Compass
Slave,
or Digital (NMEA)
INTERFACING: Standard NMEA: 0183
DUAL INPUT PORTS
OUTPUT: Selectable HDG or HDT sentence
ALARMS: Watch-keeping System, Full Helm, Off Course, Drive Stall,
Overload and Compass Fault
CM 880 CONTROLLER
DIMENSIONS: 290mm x 144mm x 111mm
MOUNTING: Flush mount or tilt bracket
INPUT VOLTAGE: 10-30 V Nominal. 35V Max
OUTPUT DRIVE: 2 Amps
CM125 RUDDER FEEDBACK
DIMENSIONS: Base: 100mm dia. Height: 125mm
Actuator Arm: 165mm
MOUNTING: Horizontal, vertical, inverted
CM427 FLUXGATE COMPASS
OUTPUT: Sine/Cosine
ACCURACY: 2degrees RMS
ROLL/PITCH: +/- 35 degrees
DIMENSIONS: 95mm dia. x 55mm
CABLE: 8m
REMOTE CONTROL
Hand-held Cable Remote, Jog Lever or Electric Wheel Steering
CM626 RATE GYRO
Provides a far steadier course than any autopilot using only
fluxgate compass, and completely overcomes any acceleration
effects or magnetic field influences.
DIMENSIONS: 95mm dia x 55mm
HYDRAULIC STEERING
A range of self-contained continuous running solenoid activated
pump kits to suit various size hydraulic steering systems.
ANALOGUE STEERING INTERFACE
A CM528 Analogue Steering Interface provides control to propulsion
systems such as Kamewa, Rolls Royce and Ulstein.
The specifications above are correct at the time of publication.
Coursemaster reserves to the right to modify specifications
in the interest of improving product quality.
|
